This page will note down that all the Juniper specific details that I come across. This page should be pretty full as in my current role (as of 17/4/2015) we are a juniper house. I will be working on mostly juniper equipment, during my working day. So just like my Linux Notes, this is here to accommodate my laziness! Enjoy :p
- Configuring Virtual Chassis on Juniper EX Series
- Junos Firmware Upgrade: EX Series and Single SRX node
- Correcting EX Switch booted from Backup Partition
- How to enable IPv6 flow (or packet) mode on SRX Series Firewall
- Creating a HA Juniper SRX Chassis Cluster
- Chassis Cluster Failover part 1
- Chassis Cluster Failover part 2
- Upgrading Chassis Cluster
- Disabling Chassis Cluster
- Configuring VPLS
- Junos Space Password Recovery
- Juniper EX Virtual Chassis Part 2
- Virtual Chassis Upgrade with Minimal Downtime
- Configuring a Virtual Chassis on QFX5100
- VRRP between IOS and Junos
- Configuring VRRPv3
- Stateless Address Autoconfiguration
- Clearing IDLE TTY sessions
- Configuring Firewall Filters
- SNMP over a Routing Instance
- Leaking Routes between Routing Tables
- Stateful Auto-Configuration with DHCPv6
- Configuring IPv4 DHCP on a Juniper SRX
- Upgrading a MX Series Router
- Configuring L2VPNs on Junos
- BGP FlowSpec
The following two tabs change content below.
Keeran Marquis
Network Engineer
Keeran Marquis is a Network Engineer. His main goal is to learn everything within the Networking field, pick up a little bit of scripting, be a poor man sysadmin and share whatever he knows! All Posts are his own views, opinions and experiences, no guarantees they will work for you but point you in the right direction 🙂
Latest posts by Keeran Marquis (see all)
- Life and Times of an Unemployed Professional Speed Dater #3 - August 5, 2018
- Life and Times of an Unemployed Professional Speed Dater #2 - August 5, 2018
- Life and Times of an Unemployed Professional Speed Dater #1 - August 5, 2018
Your blog is cool , well done !
Hello, I have an existing Ex4200 virtual chassis of 9 members, and we recently decided to replace them with 2 EX4300. Can you advice how to move the entire configuration of 4200 to 4300? Note, the 4200 are connected to QFX5100, and the same will apply for the 4300.
you will need to look at ELS as the syntax will be different from 4200 to 4300 so you will be best to use the junos config checker imo